[Nilesh Butani]

Sir,

Actually we are using Linux board and PPPD driver run in linux board. our socket modem (MTSMC-G2-GP) attached with linux board on UART of board.

now we have some confusion if we configure sockt modem with linux board IP and PORT NO. Does Modem (MTSMC-G2-GP) send GPS data on that Socket of linux board?

I have open a (UDP Server) socket on linux board and I think Modem work as a client so is it possible Socket Modem send data on my Board using that socket by PPPD driver?

I have other problem like we use this (MTSMC-G2-GP) Modem first time and my PPPD driver working fine with (MTSMC-G2) Modem. so is there any changes needed in PPPD driver code to support (MTSMC-G2-GP) Modem?

[Nilesh Butani]

Thanks a lot for support!!!!

OK ,

suppose,if I will use socket (SERVERCLIENT—-TCP)modem ,can I GPRS/GSM data parallel using this theory?…..

IF possible or not then tell me how to use the socket modem for both communication allow parallel???

& sorry ,if you can’t understand my question then guide me how use to this device????

[Nilesh Butani]

Sir,

I repeat the question….what I have a problem….

In device MTSMC-G2-GP already GPRS communication Established by one Serial communication path……

Actually problem is that…. In same serial communication path can I access also GPS Enable or configure GPS command…..like

1. AT#GPSSERV = 199.199.50.50

2. AT#GPSPROTO = 1

3. #GPSGPGGA = 1

AND I want to both GPRS & GPS command access from same serial path..at one by one !!!!!!!is that possible or not????

[Nilesh Butani]

dear sir,

Actually i have a problem in device MTCDP-G2-GP

there is only one communication path for gprs access pppd driver…

in same path can I access GPS command or not???

if possible then Please guide me…..

Thanks,

Nilesh.

[Author]

Posts