Lucas Li

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 14, 2015 at 2:20 pm in reply to: mtsmc-e1 #9622
    Lucas Li
    Participant

    The antenna wire was connected in the wrong place. The modem has registered.

    October 14, 2015 at 1:58 pm in reply to: mtsmc-e1 #9621
    Lucas Li
    Participant

    Thanks for the response.
    AT+CREG? gives 0, 0 which is not registered.
    AT+CPIN? says ready.
    Is the modem ready to use out of the box after apn is configure or should an external antenna be attached? The modem comes with a wire connecting at the antenna connector. In this state, I get 99,99 for CSQ. I tried removing the wire and connecting an external antenna at the jack next to the SIM card. I get 11, 99 for CSQ but CREG still gives 0, 0.

    Thanks
    Lucas

    May 14, 2014 at 3:41 pm in reply to: How to tell if modem is using 2g or 3g for data connection #5780
    Lucas Li
    Participant

    Thanks a lot for your response. I’ll try 2g after setting the ws46 to 12. I heard at&t is taking their 2g service anyways.

    May 14, 2014 at 3:24 pm in reply to: How to tell if modem is using 2g or 3g for data connection #5777
    Lucas Li
    Participant

    The datasheet for MTSMC-H5 says it supports 2g and 3g. I put an old 2G sim card in the modem and data cannot connect at all. If the h5 modem does support 2G then could this be caused by 2g configuration not turned on?

    Thanks

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)