James Skinner

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • June 26, 2012 at 12:16 am in reply to: Re: How to specify the usb device? #4008
    James Skinner
    Participant

    Thanks Bryan.

    udev put me on the right track.

    Also, it seems that my USB devices that I’m using show up in /dev/serial/by-id directory when I plug them in which should be what I will work with.

    James

    June 20, 2012 at 5:00 pm in reply to: Re: How to specify the usb device? #4006
    James Skinner
    Participant

    I’m plugging in a couple of USB devices to the OMG module.

    The USB driver ftdi_sio is loaded fine but the device attached varies. For example, one time it may be /dev/ttyUSB2 and another time it may be /dev/ttyUSB3. This creates a problem for a application since I have to manually use dmsg figure out which device is used.

    Any suggestions?

    James

    December 29, 2011 at 8:13 pm in reply to: Re: step-by-step instructions for enabling php #3629
    James Skinner
    Participant

    It works! Thanks Bryan for the excellent help.

    I just used the standard distribution that you ship so I did not have to worry about bitbaking therefore I did not have to perform steps 1 and 2.

    Thanks,

    James

    December 28, 2011 at 2:31 am in reply to: Re: step-by-step instructions for enabling php #3627
    James Skinner
    Participant

    Are there any step-by-step instructions for enabling php on the CPD using the lighthttp web server? Just wanted to make sure that I get all of the steps right. Thanks.

    May 2, 2011 at 9:15 pm in reply to: AT command interface #3141
    James Skinner
    Participant

    Thanks, I have the new MTCDP-H4 (HSPA) and was able to enter AT commands using microcom. I did notice though AT+CSQ and ATI returned the values that I was expecting but was not able to get other commnads such as AT!GSTATUS? and AT!GSMINFO? to return anything but OK. Any idea why?

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)