MultiTech Developer Resources » eric gourlaouen's Replies

eric gourlaouen

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
May 4, 2017 at 8:50 am in reply to: Resetting the Conduit to factory state #18929

eric gourlaouen
Participant

Hi Jeff,

Thanks for your answer – I ended up using U-boot to flash the Conduit, using the debug cable, using this method: http://www.multitech.net/developer/software/mlinux/using-mlinux/flashing-mlinux-firmware-for-conduit/ so I could restore the system to a factory state.

Best,

Eric

May 4, 2017 at 5:45 am in reply to: Resetting the Conduit to factory state #18923

eric gourlaouen
Participant

Hi, I’m having a similar issue with a Multitech Conduit. When experimenting with it, I accidentally added a startup script that just hangs before the shell is started on debug mode – and SSHD is not available. Is there any way I could force the fs factory reset without having access to a shell?
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)