Timing Advance Values

Home › Forums › MultiConnect OCG › Timing Advance Values

Tagged: 

Viewing 1 post (of 1 total)
  • Author
    Posts
  • February 28, 2014 at 12:55 pm #5569
    Jordan Larson
    Participant

    Hello,

    I am currently using a G2 modem with the MultiConnect board that offers an AT command called “AT+CCED” which gives me the timing advance measurements from my main cell AND the neighbouring cells. Based on tests that we did recently we’re not sure that we are interpreting these measurements correctly because we are getting the same timing advance number for the same Cell ID over a trajectory of 4000 meters where the granularity of a Timing Advance is supposed to be 550 meters. We were wondering if any of you had any insight into what the Timing Advance measurement is doing or if you could put us into contact with someone who would know what is going on.

    Thanks,
    Jordan Larson

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.