The interface firmware FAILED to reset/halt the target MCU

Home Forums Dragonfly The interface firmware FAILED to reset/halt the target MCU

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #19127
    TaeYang
    Participant

    I am using MTMDK-ST-MDOT products.
    When USB is plugged into PC, “There is not enough space on MULTITECH”
    so, tried to find a solution at https://developer.mbed.org/questions/8021/Problem-with-STM32F401-Nucleo-board/ but it failed.
    here Using en.stsw-link009, the change from 12KB to 32KB succeeded.

    However, MTDOT-BOX-EVB-2.1.2.bin file is not the capacity to accept.

    How can I fix it?

    #19139
    Mike Fiore
    Blocked

    Hi TaeYang,

    Is the ST-Link firmware on your MTMDK updated to the latest? You can find the FW and update instructions here:

    https://developer.mbed.org/teams/ST/wiki/Nucleo-Firmware

    What OS and OS version are you using?

    Make sure the mDot is properly seated on the MTMDK as well.

    Cheers,
    Mike

    #19140
    Mike Fiore
    Blocked

    Just saw that you mentioned the MTDOT-BOX/EVB. If you’re using the ribbon cable to connect the dotbox/evb to the MTMDK, make sure the orientation is correct on both sides.

    Update firmware using binary file

    Cheers,
    Mike

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.