RN2483 + Conduit : AEP Model – Node Red

[Edson Calsin]

Hi,

I’m using conduit gateway AEP with the RN2483 module from microchip in ABP mode.
My configuration is :

Gateway version 1.1.2
– Frequency band: 868
– Additional Channels Frequency (MHz): 867.5
– Tx Power (dBm): 26
– Rx 1 DR Offset: 0
– Rx 2 Datarate: 12

RN2483 version 1.0.1

mac set ch drrange 0 0 6
mac set ch status 0 on
mac set ch drrange 1 0 6
mac set ch status 1 on
mac set ch drrange 2 0 6
mac set ch status 2 on
mac set devaddr 00000005
mac set nwkskey iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
mac set appskey iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
mac save
mac join abp

To reduce consumption, I turn off module RN2483 between each sent frame.

I want to use ADR in my system, I had a problem and I had solution here.

So now I have version 1.2.2 of gateway, but when I send messages I can’t see them in the Node Red. However I can see in the Statistics of gateway ( Status & Log > Statistics > LoRa ).

I did some tests :
I reinstalled version 1.1.2 of gateway and I can see all messages in the Node Red and Statistics.
I reinstalled version 1.2.2 of gateway and I still have the same problem.

There is something I forgot in my configuration with new version 1.2.2 ?

Thanks,

Edson

• This topic was modified 8 years, 9 months ago by Edson Calsin.

[Jason Reiss]

Please open a ticket at support.multitech.com so we can exchange configuration and log files.

[Jose Navarro]

I confirm that I see the same behaviour with a Multiconnect Conduit AEP 915MHz and using a Microchip RN2903.
Going back to 1.1.2 fixes the issue of not seeing messages in Node-Red debug.

Regards
-Jose

[Author]

Posts