Problem resetting Conduit

[wkhatch@unimar.com]

I have an MTCDT-LVW2 AEP model. I first switched it mLinux 3.x, using the flash on reboot method, which worked as expected. I then tried upgrading mLinux to 4.x, and since, the conduit is stuck on solid green status, and I’m unable to connect via the debug port or ssh over ethernet. I decided to try resetting the device, following along with the product manual info. I’m not sure which one to follow, being it’s an aep model that was subsequently flashed to mlinux, and now appears to be stuck in an inconsistent state, but, neither short pushes, or long pushes, appear to be doing anything, so I’m uncertain how to proceed. I’d like to revert back to the installed AEP configuration, with node red enabled.

[Ismo Penttinen]

I have same problem.

[Jason Reiss]

Flashing mLinux Firmware

See “Using Auto-Flash During Reboot with image upgrade.bin”

The upgrade can be performed with mLinux and AEP upgrade files obtained from the downloads page.

[Author]

Posts