NRESET PIN Connection

Home › Forums › mDot/xDot › NRESET PIN Connection

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • July 20, 2017 at 6:22 pm #20279
    Jared Weldon
    Participant

    Hi,

    What is the recommended connection to the NRESET pin on the XDOT. Should I use a pull up resistor or keep it floating?

    I had it tied to VCC before but that caused issues. From the processors data sheet on the XDOT it seems you can leave it floating.

    July 21, 2017 at 5:26 am #20281
    Andrew Lindsay
    Participant

    Hi,
    I use a 10K resistor pullup and a 100nF capacitor between NRESET and Ground. If you then add a reset button you then connect it between NRESET and Ground.

    Thanks

    Andrew

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.