MTAC FPGA Update error.
- This topic has 1 reply, 2 voices, and was last updated 5 years, 6 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
Home › Forums › Conduit: AEP Model › MTAC FPGA Update error.
Tagged: MTAC FPGA
Jason Reiss.
openclosed@samwooeleco.comHi.
I am using MultiConnect Conduit 1.7.4, MTCDT-246A.
I tried updating from v31 to v33 and got an error.. (See log below)
mts-fpga-loader -i /usr/lib/mts-flash-binaries/mtcdt-fpga-v33
Using ap2 – /dev/spidev32765.2
Checking hardware compatibility
Found Valid Hardware: MTAC-LORA-1.5
Checking file /usr/lib/mts-flash-binaries/mtcdt-fpga-v33.hex
File verified
Erasing flash
Programming flash
Write Complete. Resetting FPGA
Reading New FPGA configuration
Checking hardware compatibility
Found Valid Hardware: MTAC-LORA-1.5
Invalid FPGA version: 255
INFO: no FPGA detected or version not supported (v255)
Upgrade Failed, Error Code: 1
Packet Forwarder is not operating normally.
Tell me how to fix it.
Jason ReissDid the card work before you tried to flash it?
Did you try the flash procedure again?
I suppose the check will return 255
$ mts-fpga-loader -c
Power down the Conduit, pull the card out and re-install carefully to ensure it is fully seated.