Microchip RN2903 join private conduit network (OTAA)

[Felix Galindo]

What commands need to be sent to the rn2903 to join a private lora network via OTAA? Since the conduit is an 8 channel gateway (set to subband of 7), is there any channel settings that need to be set on the rn2903 to have proper communication?

[Miguel Wuotto]

Hi, i have the same problem.
Any update?
Regards.

Miguel

[johann van Niekerk]

Hi Felix

Is your RN2903 a Mote or just a chip ? I have the RN2483 chip registered on my mlinux conduit via OTAA but not getting an messages in. there is a fair amount of mac commands that needs to be sent to the RN chips to set them up for comms with conduit. but first you need to insure your conduit(gateway) is correctly configure.

[johann van Niekerk]

This is the basic setup steps required. when i run these steps and ask to join the network i get denied but when looking at the conduit node list i can see i have been registered successfully

http://www.microchip.com/forums/m945840.aspx

[Author]

Posts