Join command response problem

Home › Forums › Conduit: mLinux Model › Join command response problem

Viewing 1 post (of 1 total)
  • Author
    Posts
  • December 22, 2015 at 2:02 am #10551
    Andrzej Gendek
    Participant

    Hi,

    I’m developing end-device and trying to connect to your gateway. I send join request and see it in gateway logs. I also noticed that gateway responds on RX2 window. What frequency and data rate are you using in RX2 window??
    Is it possible to set frequency plan for your gateway in configuration file?

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.