failed to join network

[TaeYang]

The title still fails to connect to the network.

Gatway: MTCDT-210L-US-EU-GB
Module : MTDOT-915-X1P-SMA-1
Developer Kit : MTUDK2-ST-MDOT

at&f

OK
at&w

OK
MultiTech mDot
Firmware: 2.0.16-mbed127
Library : 2.0.16-mbed127

OK
at+pn
1

at+fsb=4

OK
at+ni=1,nmsnetwork
Set Network Name: nmsnetwork

OK
at+nk=1,mmsnetwork
Set Network Passphrase: mmsnetwork

OK
at&w

OK
atz

OK
at+pn
1

OK
at+join
Failed to join network

You will not be able to access the gatway as it looks like this.

at&v
Device ID: 00:80:00:00:00:00:e3:3c
Frequency Band: US915
Frequency Sub Band: 4
Public Network: on
Start Up Mode: COMMAND
Network Address: 00000000
Network ID: ff?2:76:54:fd:ee:43:bb
Network ID Passphrase: nmsnetwork
Network Key: 5a.a8.b4.c0.d9.bb.16.fe.65.58.1b.54.99.6e.6e.74
Network Key Passphrase: mmsnetwork
Network Session Key: 00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00
Data Session Key: 00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00
Network Join Mode: OTA
Network Join Retries: 2
Preserve Session: off
Join Byte Order: LSB
Join Delay: 5
Join Rx1 DR Offset: 0
Join Rx2 Datarate: DR8 – SF12BW500
Join Rx2 Frequency: 923300000
App Port: 1
Link Check Threshold: off
Link Check Count: off
Error Correction: 1 bytes
ACK Retries: off
Packet Repeat: 1
Encryption: on
CRC: on
Adaptive Data Rate: off
Command Echo: on
Verbose Response: off
Tx Frequency: 0
Tx Data Rate: DR0 – SF10BW125
Tx Power: 20
Tx Antenna Gain: 3
Tx Wait: on
Tx Inverted Signal: off
Rx Delay: 1 s
Rx Inverted Signal: on
Rx Output Style: HEXADECIMAL
Dgbug Baud Rate: 115200
Serial Baud Rate: 115200
Serial Flow Control: off
Serial Clear On Error: on
Wake Mode: INTERVAL
Wake Interval: 10 s
Wake Delay: 100 ms
Wake Timeout: 20 ms
Wake Pin: DI8
Log Level: 0

OK

Should I use the same firmware as gatway?

[Author]

Posts