DL configuration

Home › Forums › Lora Network Server › DL configuration

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 13, 2018 at 4:34 am #23811
    Alex CC
    Participant

    I recently got the Conduit AEP and I want to change the state of an Adeunis Dry Contact relay.

    This device is a class A node, so I configurated it to be alive as much time as possible in order to not lose any message, so what I want to do is to let a message on the Conduit to be readed by the Adeunis Dry Contact once it’s ready.

    I updated the firmware to 1.4.16, so this version should allow me to send DL from the embedded webserver.

    I can’t figure it out how to do it correctly, could you give me some indications to formalize the sending of DL configuration?

    Thank you very much

    Regards

    June 13, 2018 at 7:17 am #23815
    Jason Reiss
    Keymaster

    Not sure what you have tried. Only through the GUI or using Node-red or other application?

    http://www.multitech.net/developer/software/aep/lorawan-aep/downlink-queue/

    Conduit mPower: LoRa Communication and Node-RED

    MQTT messages can be used to send downlinks from most applications.

    MQTT Messages

    A Class A device must send an uplink to receive the downlink payload in a receive window.

    June 14, 2018 at 2:03 am #23830
    Alex CC
    Participant

    Thank you for your reply Jason and for the informatión you sent me,

    I got send payloads through GUI. Now, what I would like to achieve is to send that payloads through NodeRed.

    How should I configurate the blocks on NodeRed in order to let packages to be readed for the Class A device?

    I didn’t get the MQTT messages, is there a place where they can be configurate?

    Regards

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.