AT Commands ERROR / NO CARRIER

Home › Forums › General › AT Commands ERROR / NO CARRIER

Tagged: , ,

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • August 29, 2012 at 6:39 pm #2786
    Rashan
    Participant

    After getting into the correct port for my device, I’m not able to configure most AT settings, they return back ERROR. When I try to activate my device I receive NO CARRIER.

    I initially thought this was an antenna issue but i was able to get a reception of 17 when calling AT+CSQ.

    The modem on the OCG-E unit is the MTSMC-EV2-U. It’s esn is registered to verizon and multitech reps haven’t been able to help much with my problem

    In response to AT!STATUS:

    AT!STATUS

    Current band: Cellular Sleep

    Current channel: 242

    SID: 21 NID: 16 1xRoam: 0 HDRRoam: 0

    Temp: 32 State: 200 Sys Mode: HDR

    Pilot acquired

    Modem has registered

    HDR Revision: A

    Seeing that the current band is Cellular Sleep makes me wonder if there is something I’m doing wrong. I am accessing the modem through microcom on port /dev/ttyUSB0. If there is anything I’m doing wrong help would be appreciated as I’m running out of places to get answers.

    If the modem is in fact working, would i be able to place a data call? What acknowledgement would I have?

    August 29, 2012 at 9:29 pm #4238
    Rashan
    Participant

    Diregard.. modem activated as data only.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.