Launch Node red App

Home › Forums › General › Launch Node red App

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 16, 2020 at 2:35 am #30955
    Perico
    Participant

    Hello,
    I’m following this page:http://www.multitech.net/developer/software/lora/conduit-aep-lora-communication/ to configure my node-red but I’m not able to open node red.
    Somebody knows the reason? My gateway runs as a network server, can affect it?

    Thanks, Perico.

    • This topic was modified 4 years, 8 months ago by Perico.
    July 16, 2020 at 8:53 am #30960
    Steve Kovarik
    Moderator

    Hi Perico

    Node-Red will take an additional 5 minutes to load after a reboot or power-up and is not accessible during that time.
    For Node-Red access
    If you configured Ethernet as WAN, go to “Administration” and “Access Configuration” and for Node-Red verify both “via LAN” and “via WAN” are enabled.
    “Submit” at the bottom of the screen then “Save & Restart”
    After the Conduit is fully booted, wait an additional 5 minutes then try to access Node-Red.

    -Best Regards

    July 16, 2020 at 10:20 am #30961
    Perico
    Participant

    Thanks Steve, problem solved.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.