DFRobot Leonardo w/XBee Socket and MDot

Home › Forums › mDot/xDot › DFRobot Leonardo w/XBee Socket and MDot

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • December 1, 2016 at 1:58 pm #15746
    Peter Keegan
    Participant

    I would like to know if it is possible to use the following MDot Modules with the DFRobot Leonardo w/XBee Socket.

    – MTDOT-915-X1-SMA 915 MHz XBee LoRa SMA
    – MTDOT-915-X1P-SMA 915 MHz XBee LoRa SMA w/Programming Header

    – https://www.dfrobot.com/wiki/index.php/DFRobot_Leonardo_with_Xbee_R3(SKU:DFR0221)” title=”DFRobot Leonardo Wiki

    The only reason I have included the MDot w/Programming Header is I intend to order the MTKIT-LORA-915 – Conduit LoRa Accessory Kit 915 MHz. I guess if the Programming Header interferes with the Leonardo board I would use header extension.

    It seems like a nice match, but I have not seen anyone mention using it.

    Also if there is a preferred Arduino XBee Shield for the UNO.

    Thank You

    • This topic was modified 7 years, 11 months ago by Peter Keegan. Reason: The link did not seem to appear
    December 5, 2016 at 7:40 am #15890
    Andrew Lindsay
    Participant

    If you are only using the factory firmware or programming the mDots in a UDK dev board then most xbee based boards should work. As I’ve not tried this myself, I’m only comparing the pinouts.

    thanks

    Andrew

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.