Ethernet Internet Access

Home › Forums › Conduit: mLinux Model › Ethernet Internet Access

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • November 24, 2016 at 12:49 pm #15635
    Ivan Londoño
    Participant

    Good Afternoon,

    I need help about Ethernet0 configuration, I had a mistake while configurating this interface, in line command I put only ifdown eth0 and push enter, forgetting the complete command (ifdown eth0 && ifup eth0 ), How can I do it, to power on eth0 again?

    Regards.

    November 25, 2016 at 1:24 am #15637
    Marco Oman
    Participant

    Yous hould still be able to access to the machine via the USB console…

    November 25, 2016 at 9:14 am #15638
    Ivan Londoño
    Participant

    Thanks for your replay.

    Access by USB console, Does it require install any dirver? and which is this? because PC doesn’t recognize any COM number in Hyperterminal or another software to view.

    Regards.

    November 29, 2016 at 9:00 am #15684
    Jeff Hatch
    Keymaster

    Ivan,

    Which version of Windows are you using? Usually a driver installation is not required.

    Jeff

    November 29, 2016 at 9:10 am #15686
    Ivan Londoño
    Participant

    Thanks for your replay, Windows version is 10, I can power on gateway eth0 again using the reset button.

    Regards.

    November 29, 2016 at 9:38 am #15692
    Jeff Hatch
    Keymaster

    Ivan,

    I have heard that one has to download and install/reinstall some drivers in order to get the debug console to work. I do not have a Windows 10 machine to replicate the process, but you should be able to Google for a solution, or set up a virtual Ubuntu Linux machine and use that to connect to the Conduit.

    Jeff

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.