How long for changing from mLinux to AEP Model take?

Home › Forums › Conduit: AEP Model › How long for changing from mLinux to AEP Model take?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • May 26, 2016 at 4:15 am #12745
    Suryadiputra Liawatimena
    Participant

    I follow instructions then reboot. Usually how long is the flash upgrading time? It takes 35 minutes and the process still going on. Is it fail or looping forever?

    The led status: Power, Status (blinking two times short, long pause repeatedly), LS on, A off, B and C on, D off.

    My usb cable is still connected to usb debug port.
    Is it save to turn off in the upgrading process and can I restart the process from the beginning?
    Can I press reset button more than 5 seconds to make factory reset (to default) and try again tomorrow with longer time?

    Thank you very much in advance.

    Warmest Regards,
    Suryadi

    May 26, 2016 at 9:04 am #12747
    Bryan Tran
    Moderator

    Hi Suryadi,

    When the Status LED is blinking, that means the unit is ready. If you connect your USB cable from the USB debug port on your Conduit to your PC, you can see what is going with your unit and once the unit is ready, it will give you a login prompt.

    Thanks,

    BT

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.