Install NETMF

Home › Forums › mDot/xDot › Install NETMF

Tagged: 

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • April 20, 2016 at 10:21 pm #12234
    Terrence Spencer
    Participant

    I understand that the STM32F411RET can run Microsoft’s .net Micro framework.
    I am a c# dev and c++ is killing me.

    Any experience or advice on porting netmf to the mDot?

    Thanks.

    April 21, 2016 at 8:47 am #12243
    Mike Fiore
    Blocked

    Terrence,

    We don’t have any official support for netmf. The C++ mbed environment is all that’s officially supported at this time.

    I’m not sure what the certification status of the product would be if you went down that road. The mDot was certified by FCC, LoRaWan, etc using the mDot software developed in mbed.

    Cheers,

    Mike

    April 21, 2016 at 8:49 am #12244
    Terrence Spencer
    Participant

    Ok, Thanks Mike.
    Is there any unofficial progress or help I might get even though it would void my certification?

    April 21, 2016 at 8:52 am #12245
    Mike Fiore
    Blocked

    I’m not aware of any unofficial progress towards that goal. However, in addition to posting on our forum, you could create a topic on the mbed site and/or search around the mbed site to see if anybody else has attempted something similar.

    -Mike

    April 21, 2016 at 8:53 am #12246
    Terrence Spencer
    Participant

    Ok, thank you for your suggestions.

    April 22, 2016 at 8:34 pm #12263
    Terrence Spencer
    Participant

    >>I’m not sure what the certification status of the product would be if you went down that road. The mDot was certified by FCC, LoRaWan, etc using the mDot software developed in mbed.

    Mike if I don’t have FCC certs, or LoRaWAN certs, that means I can’t make a commercial product or what? What are the downsides of using LoRa without certs?

    Thank you for your help.
    Terrence

    April 26, 2016 at 10:01 pm #12281
    Terrence Spencer
    Participant

    Any comment on this topic?

    April 27, 2016 at 7:10 am #12285
    Jason Reiss
    Keymaster

    You may be able to maintain certification if you are able to compile with our prebuilt libmDot. We have a gcc archive available that may be able to be used with netmf.

    Otherwise if you for go using our library, then you would need FCC/ETSI certification before commercialization.

    The advantage of LoRa certification is customer confidence that the product has been tested against the protocol in an official manner.

    April 27, 2016 at 8:49 am #12290
    Terrence Spencer
    Participant

    Thanks for that clarification Jason.

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.